CAT D4K2 LGP Hours: 2798
PAT blade, Rippers available at an additional cost.
ENGINE
Blow by- Minimal to none- - - -
Knocking- No knocking- - - -
Air cleaners- Good- - - -
Any smoke- Minimal to none- - - - Oil or fuel leaks- None visible- - - - General running condition- Runs well- - - - - - - TRANSMISSION
Gear change- HST works well- - - - Steering- Responsive- - - - Oil leaks- None visible- - - - Is the transmission noisy?- No- - - - Torque converter- No Noises- - - - Controls- Good controls- - - - General running condition- Moves well- - - - - -
UNDERCARRIAGE
Shoe width- 635mm- - - - Shoe height- 40mm, 75%- - - - Shoes - any wear in trailing edge- Slight wear- - - - Rail height- New- - - -
Any signs of link failure- No- - - -
Average diameter of pins and bushings- New- - - -
Have pins been turned on chains- New- - - -
Sprockets- New- - - - - - - IDLERS - UNDERCARRIAGE
Left side front idler- New- - - -
Right side front idler- New- - - - - - - TOP ROLLERS - UNDERCARRIAGE
Left side roller- New- - - -
Right side roller- New- - - - - -
BOTTOM ROLLERS - UNDERCARRIAGE
Roller 1- 155mm x 155mm, 70%- - - - Roller 2- 156mm x 155mm, 70%- - - - Roller 3- 156mm x 155mm, 70%- - - - Roller 4- 155mm x 156mm, 70%- - - - Roller 5- 156mm x 156mm, 70%- - - - Roller 6- 156mm x 156mm, 70%- - - - Roller 7- 156mm x 157mm, 70%- - - - - - - CAB
Cab mounts - any wear- Good mounts- - - - Any wiring for laser system- Yes- - - -
Back up alarm- Loud and clear- - - - Battery isolator switch- Manual fitted- - - - Lights- All working- - - -
Wipers- All wipers and washers work- - - -
Heater- Good heat- - - - A/C- Good cold A/C- - - - Seat condition- Works as should, good condition- - - - Cladding condition- Good condition- - - - Floor mat condition- No wear or tears- - - - Seat belt- Working- - - -
Mirrors- Rear view only- - - - Horn- Loud and clear- - - - Cab mounts- Good mounts- - - - Cab glass condition- Good condition- - - - Cab glass have any cracks?- No damage- - - - - -
BLADE
Blade width- 3100mm- - Blade height- 930mm- - Main Lift Rams, wear- L/H: 1mm x 1mm, R/H: 1mm x 1mm- - Pitch ram, wear- L/H: 2mm x 3mm, R/H: 3mm x 2mm- - Tilt ram, wear- 2mm x 2mm- - Ball joint, wear- 3 - 4mm- - C-Frame, wear- 3mm x 2mm- - Cutting edges condition- 25mm left- - - - Have cutting edges been turned?- No- - General blade condition- Good condition- - - - - -
PAINT & DECALS
Any damage to panels- No damage- - - - Paint condition- Fair- - - - Any areas repainted- No- - - - Any rust patches- Minimal- - - - - -
DIMENSIONS- Length
Width
Height- Measurements with blade straight- 4100mm
3100mm
2930mm- Measurements with blade turned- 4830mm
2680mm
2930mm- Measurement from outside to outside of tracks-
2365mm- - Measurements with blade straight- Length: 4100mm
Width: 3100mm
Height: 2930mm- Measurements with blade turned- Length: 4830mm
Width: 2680mm
Height: 2930mm- Measurement from outside to outside of tracks- Length:
Width: 2365mm
Height: